Fuel Level Sensor 0-90 ohm, 11.7 inch, Radium Engineering

ATTENTION:

1. The Radium 20-0847-XXX fuel level float cover is only compatible with the new Radium FCST (20-099X-XX).

2. For older Radium FCST versions 20-049X-XX and 20-069X-XX, the Radium 20-0747-XXX without cover must be used.

3. Radium level sensors 20-0747-203 and 20-0747-297 without cover are compatible with all Radium FCST part numbers.

This fuel level sensor uses the standard SAE 5-bolt mounting pattern, widely used with the Radium Fuel Surge Tank.

Fully sealed stainless steel construction with magnetic float.

Suitable for gasoline, diesel, water, and all alcohol-based fuels, including methanol, ethanol, E85, etc.

NOTES:

-All level sensors have a resistance of 0 Ohms (empty fuel) to 90 Ohms (full fuel) (common on many aftermarket gauges).

-Radium does not sell fuel level gauges, but a popular option is this Autometer fuel level gauge.

-To test the sensor, measure the resistance between the two wires while tilting it so the float moves.

-If purchased with a Radium Fuel Surge Tank (FCST), the sensor will come pre-installed.

-If the output of this sensor is not compatible with your original fuel gauge, consider a resistance signal converter, which can be found here.
(Radium Engineering has no experience with this product; for more information, contact Classic Instruments).

SPECIFICATIONS:

PROBE MATERIAL: 304 Stainless Steel
FLOAT MATERIAL: Buna-N Plastic

MOUNTING FLANGE: SAE 5-Bolt

MOUNTING GASKET: FKM

RESISTANCE: 0 (Empty) - 90 (Full) Ohms
PVC WIRES: 460 mm (18") with PA sleeve

CONNECTORS: Deutsch DT, 2P
OPERATING TEMPERATURE: -40 °F to +185 °F
INCLUDES:

-Level Sensing Probe
-SAE 5-Bolt GASKET
-Stainless Steel 10-32 Screws (x5)

Deutsch DT 2P Connector
-Deutsch DT Connectors (x2)

Instruction PDF